Sea-Doo VTS Trim Fix module

Introducing the Trim-FIX module for SeaDoo personal watercraft.
The Trim FIX module fixes trim operation without the need to replace, or even remove, a failed VTS housing.

VTS Housing failure is extremely common and replacement of the entire VTS Housing was required to fix this problem,,,

until now  .  .  .  .  .

"Compatible for all models with VTS"

This is the SOLUTION to the constant failing and expensive VTS Housings.

A new VTS housing costs over $300 and will surely fail again as they always do. Having to replace them every season gets costly.

 Until now, fixing trim operation on Seadoo personal watercraft was a frequent and expensive repair. The only repair option was to replace the complete VTS Housing. Only to be replaced again not long after because it will fail as they always do.  The common cause of failure is due to the control module, gauge position sensor, and electronics being located internally within the VTS Housing and seems that no matter what is done, they take on moisture due to their design and location. The electronics inside the housing are encapsulated and non-serviceable, making replacement of the complete VTS Housing as the only option for repair.  The electronic components that operate the gauge to indicate trim position are also located inside the VTS Housing  as well and are also non-serviceable, again leaving no option but to replace the complete housing to repair the problem. As many know, replacing the VTS housing is quite involved,  requiring skill to be done correctly, special tools are needed, the repair is time consuming, and if it not done correctly, a leak into the hull and the craft will take on water introducing a variety of damages which could have been avoided. Replacing the VTS housing is repair that should be performed by a professional technician.  Then,,,, after that is all done, it won't be long and it will be time to do it all again when the VTS housing fails again, which it is sure to do.

The Trimfix System eliminates all of this, without replacing, or even removing the VTS Housing at all !

                    Trimfix features include:

• Compatible for all models with VTS

• The TrimFix works with your existing switch and gauge

• Connects easily to existing wiring

• No need to remove the VTS Housing at all

• Travel stops at max up and down positions

• Has warranty with free replacement for as long as you own your ski

• plus more!

 How the TrimFix System solves all of this is simple,  by replacing the VTS Housing's internal control module, gauge position sensor and electronics with external components. The electronic control module and gauge position sensor mount and install externally from the VTS housing and connect right to the existing wiring,  the gauge position sensor attaches on the outside of the VTS Housing connecting to the original wiring.  Again eliminating the need to replace, or even remove the VTS housing

 Installation is easy and takes an average of 30-45 minutes to install. No special tools needed, full illustrated instructions are included.